Finite Element Modeling and Analysis of Warm Forming of Aluminium Alloys Validation Through Comparisons With Experiments and Determination of A Failure Criterion  

Oleh:

Koc, Muammer ; Ghosh, Amit ; Jun, Ni ; Hong, Seok Kim

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 128 no. 3 (Agu. 2006), page 613-621.
Topik: finite element; warm forming; lightwights materials; finite element analysis; failure criterion

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.8 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

In this study, thermomechanically coupled finite element analysis (FEA) was performed for forming aluminum rectangular cups at elevated temperatures. In order to identify the onset of a failure during FEA, applicability, accuracy, and repeatability of three different failure criteria (maximum load, minimum thickness, and thickness ratio) were investigated. The thickness ratio criterion was selected since it resulted in accurate prediction of necking - type failure when compared with experimental measurements obtained under a variety of warm forming conditions. Predicted part depth values from FEA at various die - punch temperature combinations and blank holder pressures conditions were also compared with experiments, and showed good agreement. Forming limit diagrams were established at three different warm forming temperature levels (250° C, 300° C, and 350° C). An increasing limiting strain was observed with increasing forming temperature both in FEA and experiments. In addition, strain distributions on the formed part obtained under different die - punch temperature combinations were also compared to further validate the accuracy of FEA. A high temperature gradient between die and punch (T die > T punch) was found to result in increased formability ; i. e., high part depths.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali