Deteksi Keausan Alat pada Proses Pengeboran Sumber Alam  

Oleh:

Halim, Siana ; Felecia

Jenis: Article from Journal - ilmiah nasional - terakreditasi DIKTI - non-atma jaya
Dalam koleksi: Jurnal Teknik Industri vol. 14 no. 2 (Dec. 2012), page 123-128.
Topik: Change point detection; drilling; mean time between failures
Fulltext: 18539-21832-3-PB.pdf (358.97KB)

Isi artikel

In this paper we applied change point detection methods for failures detection in the drilling process. We calculated the change points on three drilling parameters, i.e., the weight on bit, top drive torque and rate of penetration. Using the concept of reliability, we measured the time between change points as the time between failures. The minimum of mean time between change points from those three parameters is suggested to be the time for monitoring the drilling process.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali