Design and Fabrication of Silicon Condenser Microphone Using Corrugated Diaphragm Technique  

Oleh:

Zou, Quanbo ; Li, Zhijian ; Liu, Litian

Jenis: Article from Bulletin/Magazine
Dalam koleksi: Journal of Microelectro Mechanical System vol. 5 no. 3 (1996), page 197-204.
Topik: SYSTEM DESIGN; design; fabrication; silicon; condenser; microphone; diaphragm technique

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ30.1 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

A novel silicon condenser microphone with a corrugated diaphragm has been proposed, designed, fabricated and tested. The microphone is fabricated on a single wafer by use of silicon anisotropic etching and sacrificial layer etching techniques, so that no bonding techniques are required. The introduction of corrugations has greatly increased the mechanical sensitivities of the microphone diaphragms due to the reduction of the initial stress in the thin films, For the purpose of further decreasing the thin film stress, composite diaphragms consisting of multilayer (polySi /SixNy / polySi) materials have been fabricated, reducing the initial stress to a much lower level of about 70 MPa in tension. Three types of corrugation placements and several corrugation depths in a diaphragm area of 1 mm2 have been designed and fabricated. Microphones with flat frequency response between 100 Hz and 8 ~ 16 kHz and open - circuit sensitivities as high as 8.1 ~ 14.2 mV/Pa under the bias voltages of 10 ~ 25 V have been fabricated in a reproducible way. The experimental results proved that the corrugation technique is promising for silicon condenser microphone.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali