Detail The New Profile of FRP Composite Roofing Sheets (di dalam International Journal of Mechanical Engineering Research (IJMER) Vol 2, No 3 (2012), pp. 223-234 Bibliografi Author: Setyanto, Djoko ; Jamasri ; Suhendro, Bambang ; Tontowi, Alva Edy Topik: new profile; continuous lamination machine; mechanical locking system; JABFUNG-FT-DJS-2022-05 Bahasa: (EN )     Penerbit: Research India Publications     Tempat Terbit: India    Tahun Terbit: 2012     Jenis: Article - diterbitkan di jurnal ilmiah internasional Fulltext: IJMER v2n3 Djoko Setyanto.pdf (1.12MB; 8 download) [Informasi yang berkaitan dengan koleksi ini di internet] Abstract Fiberglass reinforced plastic (FRP) composite roofing sheets are used as roofing and clading for industrial and commercial building on corrosive environment. Self drilling screw is used to install conventional roofing sheet to the purlin of the construction which causes hole on roofing sheets. As the result, the hole increases the possibility of roofing sheets failure. The common conventional profiles roofing sheets have a simple crest dimension where the upper side is smaller than the bottom side. The conventional roofing sheets are produced in a continuous lamination machine with a set of simple geometric mouldings. The new profile of FRP roofing sheet is specially designed to improve the conventional profiles which can be fixed to purlins without holes. The new roofing sheets are fixed to purlins with mechanical locking system. The locking mechanism system of roofing sheets is fulfilled by designing the crest profile where the upper side is wider than the bottom side. This paper describes the designing process of the new profiles, the locking mechanism system, and the production process of the new profiles in a continuous lamination machine. Opini Anda Klik untuk menuliskan opini Anda tentang koleksi ini! Lihat Sejarah Pengadaan  Konversi Metadata   Kembali

Copyright © 2006, 2007 Unika Atma Jaya, all rights reserved