Analysis of Feed Errors in Tapping by Contact Stress Model  

Oleh:

Dogra, Ajit Pal S. ; Kapoor, Shiv G. ; DeVor, Richard E.

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 124 no. 2 (May 2002), page 248-257.
Topik: stress; feed errors; tapping; contact stress model

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.3 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

One of the most common tapping errors, mismatch of tap feed rate and the thread pitch, has a significant effect on the tapping thrust signal and the resultant thread profile. The underfeed of the tap leads to an upward pull on the workpiece and overfeed causes a downward push. Tapping experiments are conducted with intentionally magnified feed errors to study the phenomenon and aid in the model development. Using contact stress theory for elastic materials, a model for tap - workpiece interaction is developed and integrated with the mechanistic force model developed earlier to predict the tapping forces. In most cases there was a good agreement between the simulations of combined model (contact stress model coupled with mechanistic model) and the experimental results. Tap tooth design with relief on the flank has been shown to significantly reduce the tapping thrust sensitivity to the feed error, thereby affecting the tool life and improving the thread quality.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali