Anda belum login :: 27 Nov 2024 05:19 WIB
Detail
ArtikelPengolahan Limbah Organik (Fenol) dan Logam Berat (Cr6+ Atau Pt4+) Secara Simultan dengan Fotokatalis TiO2, ZnO-TiO2, dan CdS-TiO2  
Oleh: Slamet ; Arbianti, R. ; Daryanto
Jenis: Article from Journal - ilmiah nasional - terakreditasi DIKTI
Dalam koleksi: Makara Journal of Technology vol. 9 no. 2 (2005), page 66-71.
Topik: Photocatalysis; Ti02; Phenol Degradation; Recovery of Cr and Pt
Ketersediaan
  • Perpustakaan Pusat (Semanggi)
    • Nomor Panggil: MM64.2
    • Non-tandon: 1 (dapat dipinjam: 0)
    • Tandon: tidak ada
    Lihat Detail Induk
Isi artikelSimultaneous Treatment of Organic (Phenol) and Heavy Metal (Cr~ or Pt4) Wastes over Ti02, ZnO-Ti02 and CdS-Ti02 Photocatalysts. Treatment of heavy metal (Cr6~ and Pt4~) and organic (phenol) wastes has been studied using the relatively new method, i.e. simultaneous photocatalytic process over Ti02 photocatalysts in the batch photoreactor. Following the photocatalytic reduction of the heavy metal wastes, recovery of Cr and Pt was carried out by precipitation and leaching method, respectively. The experimental results show that in the simultaneous photocatalytic system, there is a synergism effect between the photocatalytic reduction of heavy metal waste (Cr6~ or Pt4~) and the oxidation of organic waste (phenol), so that increasing the conversion of each other. Dopant of ZnO with the optimum loading (0.5 wt%) could slightly increase the performance of biO2 photocatalyst in photocatalytic treatment of the wastes. Whereas CdS dopant with the optimum loading of 1 wt% could significantly enhance the performance of Ti02 photocatalyst in simultaneous Cr(VI) reduction and phenol oxidation with the highest conversion of _ 97 % and 93 %, respectively. Photocatalytic reduction of Pt(IV) under O.5%ZnO-Ti02 and 1%CdS-Ti02 photocatalysts effectively occurred with a high conversion (> 99 %) in 2 hours irradiation of UV. The optimum precipitation condition of Cr(III) recovery was achieved at pH = 9, with the efficiency of recovery was 91 %. Optimum temperature of leaching process in Pt recovery was 100 °C, with the efficiency of recovery was 86 %.
Opini AndaKlik untuk menuliskan opini Anda tentang koleksi ini!

Kembali
design
 
Process time: 0.03125 second(s)