An Experimental Study of Cutting Forces in High-Speed End Milling and Implications for Dynamic Force Modeling  

Oleh:

Mativenga, P. T. ; Hon, K. K. B.

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 127 no. 2 (May 2005), page 251-261.
Topik: cutting force; cutting forces; high - speed; end milling; dynamic force modeling

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.7 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

The characteristics of high - speed machining (HSM) dynamic milling forces was investigated. Recent studies in chip segmentation are discussed. A Mikron 700 High - Speed Machining Center was used in the end-milling of AISI H13 tool steel using PVD TiN coated two flute micrograin carbide tools. Dynamic force signals were studied using a real-time data acquisition system for spindle speeds from 3,750 to 31,500 rpm for a 6 mm dia tool. Frequency domain studies were also carried out for a larger tool of 12 mm dia for spindle speeds between 10,000 and 40,000 rpm. The trend and frequency domain aspects of the dynamic forces were evaluated and discussed. The fundamental concept of modeling cutting forces based on chip morphology is revisited. A new basis for modeling dynamic forces from the static component and harmonic contributions is presented. This approach for modeling the dynamic HSM force signal accounts for secondary harmonics.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali