Analysis of The Cutting Force Components and Friction in High Speed Machining  

Oleh:

Sutter, G. ; Molinari, A.

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 127 no. 2 (May 2005), page 245-250.
Topik: friction; cutting force; components; friction; high speed machining

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.7 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

An original experimental device is used to reproduce conditions of orthogonal cutting for a wide range of cutting speeds (from 15 to about 100 m/s) (Sutter et al.). Improvement of the initial device (Sutter et al.) makes it possible to record both values of normal and tangential forces in orthogonal cutting. An analysis of the tool – chip friction is then possible for a large range of cutting speeds. The evolution of cutting force components as well as the evolution of the friction coefficient are presented and analyzed. In addition, the process of chip formation during high speed machining is illustrated by photographic recording with a high speed camera.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali