Micro and Sub-Micromachining of Type IIa Single Crystal Diamond using A Ti:Sapphire Femtosecond Laser  

Oleh:

Molian, Pal A. ; Ramanathan, Diwakar

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 124 no. 2 (May 2002), page 389-396.
Topik: crystal structure; micro machining; single crystal diamond; femtosecond laser

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.3 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

A 200-fs pulsed Ti : Sapphire laser was used to micromachine Type IIa single crystal diamond. The effects of pulse energy and exposure time were investigated. Both blind and through holes were generated by trepanning and percussion modes. Trenches were produced by the direct - writing mode. Scanning electron and atomic force microscopy analysis revealed that the holes are in the range 0.65 – 100 µm and are free from taper. In addition, there was little recast layer around the holes. The damage threshold was approximately 4 J / cm2, which is smaller than those obtained from other lasers. A two-temperature model was used to establish the electron temperatures and to predict the ablation depth per pulse. It is evident from this work that femtosecond lasers are capable of producing micron and sub - micron structures with very high precision.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali