Augmentation of Thin Falling-Film Evaporation on Horizontal Tubes Using An Applied Electric Field  

Oleh:

Dessiatoun, S. V. ; Darabi, J. ; Ohadi, M. M.

Jenis: Article from Bulletin/Magazine
Dalam koleksi: Journal of Heat Transfer vol. 122 no. 2 (May 2000), page 391-398.
Topik: heat of evaporation; augmentation; thin falling - film; evaporation; horizontal tubes; electric field

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ90.1 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

Heat transfer enhancement of falling - film evaporation on commercially available horizontal tubes using an applied electric field was studied experimentally. The tube surfaces tested included : smooth, 19 fins per inch (19 fpi) low - fin type, and Turbo BIII which is a state - of - the - art commercially available boiling tube. The nominal outside diameters of all the tubes were 19 mm. Experiments were performed with R - 134a at a saturation pressure of 550 kPa. Effects of heat flux, film flow rate, applied electric field potential, and heat transfer surface on the heat transfer coefficient were investigated. In addition, the effect of Poloyl - ester oil on the heat transfer coefficients was also investigated. Experiments were conducted for oil concentrations ranging from 0.5 percent to 5 percent on a mass basis. Small concentrations of a poloyl - ester lubricant were found to improve the heat transfer performance, while large concentrations reduced the heat transfer coefficient.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali