Detail Penentuan Faktor Koreksi Pengali Vertikal Persamaan Niosh Untuk Pekerja Pria Industri Indonesia Berdasarkan Aspek Psikofisik, Fisiologi, dan Biomekanika Bibliografi Author: CHANDRADINATA, HENDRA ; Yanto (Advisor) Topik: NIOSH; Vertical Multiplier; Biomechanics; Psychophysical; Physiology; RWL. Bahasa: (ID )     Penerbit: Program Studi Teknik Industri Fakultas Teknik Unika Atma Jaya     Tempat Terbit: Jakarta    Tahun Terbit: 2010     Jenis: Theses - Undergraduate Thesis Fulltext: Hendra Candradinata Undergraduated Theses.pdf (2.81MB; 70 download) Hendra Chandradinata-PENDUKUNG.pdf (431.02KB; 4 download) Ketersediaan Perpustakaan Pusat (Semanggi) Nomor Panggil: FTI-513 Non-tandon: tidak ada Tandon: 1  Lihat Detail Induk Abstract Each of these industrial workers would be familiar with the term low back pain or low back injury. The two terms mentioned above is a pain or injury to the spine. According Ergonows in 2008, statistics report that approximately 20-30% of the total workers' compensation costs derived from low back pain. NIOSH recommends the imposition of an equation in 1981 which was revised in 1991. NIOSH equation is derived from the western United States, where the body of the western people have proved greater than the people asia especially Indonesia. Factor contained in the RWL based on research data on American workers and NIOSH review used in determining the multiplier factor is a partial review. So far, the formula or the results of research conducted by an overseas institution in Indonesia were applied without the adjustment. This can cause errors in the load limit up to the Indonesian people, especially the Indonesian industrial workers who often carry the load. In this study, using a sample of industrial workers of Indonesia, conducted the review as a whole in terms of psychophysical, physiological, and biomechanics to determine the vertical reducer factors and vertical multipler factor from NIOSH equation. The results of this study is - Rapture position under the height knuckle (0cm = V = 70.05cm): VM = 1 – 0.005037 (70.05 – V) - Rapture position above the height knuckle (70.05cm= V=165.83cm): VM = 1 – 0.0004868(V – 70.05) - V maximum height allowed is 165.83 cm. Opini Anda Klik untuk menuliskan opini Anda tentang koleksi ini! Lihat Sejarah Pengadaan  Konversi Metadata   Kembali

Copyright © 2006, 2007 Unika Atma Jaya, all rights reserved