Detail Thermomechanical Behavior and Modeling Between 350°C and 400°C of Zircaloy-4 Cladding Tubes From An Unirradiated State to High Fluence (0 to 85·1024 nm–2, E>1 MeV)   Oleh:  Schäffler, I. ; Geyer, P. ; Bouffioux, P. ; Delobelle, P. Jenis: Article from Bulletin/Magazine Dalam koleksi: Journal of Engineering Materials and Technology vol. 122 no. 2 (2000), page 168-176. Topik: TUBES; thermomechanical behaviour; modelling; tubes Ketersediaan Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ87.1 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada     Lihat Detail Induk Isi artikel This paper first describes the effect of neutron irradiation on the thermomechanical behavior of stress-relieved Zircaloy - 4 fuel tubes that have been analyzed after exposure to five different fluences ranging from nonirradiated material to high burnup. In the second part, a viscoplastic model is proposed to simulate, for different isotherms, 350 °C < T < 400 °C, out - of - flux anisotropic mechanical behavior of the cladding tubes over the fluence range 0 < o < 100 · 10(24) nm(–)2 (E > 1 MeV). The model, identified for tests conducted at 350 °C, has been validated from tests made at 380 °C and 400 °C. The model is capable of simulating strain hardening under internal pressure followed by a stress relaxation period, the loading producing an interaction between the pellet and cladding. Introduction of a state variable characterizing the damage caused by a bombardment with neutrons into the model has allowed us to simulate the irradiation - induced hardening and creep rate decrease, as well as the saturation noticed after two cycles of irradiation (45·10(24) nm(–2) (E > 1 MeV)) in a pressurized water reactor (PWR). Finally, the numerical simulations show the model is able to reproduce the totality of the thermomechanical experiments. Opini Anda Klik untuk menuliskan opini Anda tentang koleksi ini! Kembali

Copyright © 2006, 2007 Unika Atma Jaya, all rights reserved