Optimization of CI Reative 195A Degradation Using Photochemical Method  

Oleh:

Sudarjanto, Gatut

Jenis: Article from Journal - ilmiah nasional - tidak terakreditasi DIKTI
Dalam koleksi: Infomatek: Jurnal Informatika, Manajemen dan Teknologi vol. 9 no. 2 (Jun. 2007), page 87-100.
Topik: Decolourization; Photochemical; Reactive azo-dye; Textile; UV/H2O2

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: II26.6 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

Photochemical method using UV/H2O2 was utilized to decolourized CI Reactive Red 195A. In this work, the UV radiation source was a low-pressure mercury arc lamp (60W emitting at 253.7nm). Using the combined UV/H2O2 process, the effects of initial hydrogen peroxide dosage, dye concreation, pH and temperature were examined to determine the optimum operating conditions of the treatment process. Complete decolourization of 100mg/L dye was achieved in the relatively short time of 20-30 minutes irradiation. Faster decolourization was achieved at low pH and high temperature. The removal rate increased initial concentration of H2O2 up to an optimum value (approximately 900mg H2O2/L). However, even after near complete removal of the active dye from solution, approximately 60% of COD was still remaining, indicating only partial breakdown of the dye molecule. In general, the result indicates that the UV/H2O2 technology has a good potential for removing dyestuff from waste water, but additional treatment is required to achieve further degradation of the organic intermediates and possibly reduce the UV irradiation time and chemical conasumption.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali