Tool Temperature in Titanium Drilling  

Oleh:

Shih, Albert J. ; Rui, Li

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 129 no. 4 (Aug. 2007), page 740-749.
Topik: temperature; tool temperature; titanium drilling

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.10 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

The spatial and temporal distribution of tool temperature in drilling of commercially pure titanium is studied using the inverse heat transfer method. The chisel and cutting edges of a spiral point drill are treated as a series of elementary cutting tools. Using the oblique cutting analysis of the measured thrust force and torque, the forces and frictional heat generation on elementary cutting tools are calculated. Temperatures measured by thermocouples embedded on the drill flank face are used as the input for the inverse heat transfer analysis to calculate the heat partition factor between the drill and chip. The temperature distribution of the drill is solved by the finite element method and validated by experimental measurements with good agreement. For titanium drilling, the drill temperature is high. At 24.4 m / min and 73.2 m / min drill peripheral cutting speed, the peak temperature of the drill reaches 480° C and 1060° C, respectively, after 12.7 mm depth of drilling with 0.025 mm feed per cutting tooth. The steady increase of drill temperature versus drilling time is investigated.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali