Study of The Size Effects and Friction Conditions in Microextrusion—Part II : Size Effect in Dynamic Friction for Brass-Steel Pairs  

Oleh:

Mori, Lapo F. ; Espinosa, Horacio D. ; Jian, Cao ; Krishnan, Neil

Jenis: Article from Journal - ilmiah internasional
Dalam koleksi: Journal of Manufacturing Science and Engineering vol. 129 no. 4 (Aug. 2007), page 677-689.
Topik: friction; size effects; friction; microextrusion; dynamic friction; brass - steel pairs

Ketersediaan

Perpustakaan Pusat (Semanggi) Nomor Panggil: JJ93.10 Non-tandon: 1 (dapat dipinjam: 0) Tandon: tidak ada

Lihat Detail Induk

Isi artikel

In this paper, the results of experiments conducted to investigate the friction coefficient existing at a brass - steel interface are presented. The research discussed here is the second of a two - part study on the size effects in friction conditions that exist during microextrusion. In the regime of dimensions of the order of a few hundred microns, these size effects tend to play a significant role in affecting the characteristics of microforming processes. Experimental results presented in the previous companion paper have already shown that the friction conditions obtained from comparisons of experimental results and numerical models show a size effect related to the overall dimensions of the extruded part, assuming material response is homogeneous. Another interesting observation was made when extrusion experiments were performed to produce submillimeter sized pins. It was noted that pins fabricated from large grain - size material (211 µm) showed a tendency to curve, whereas those fabricated from billets having a small grain size (32 µm), did not show this tendency. In order to further investigate these phenomena, it was necessary to segregate the individual influences of material response and interfacial behavior on the microextrusion process, and therefore, a series of frictional experiments was conducted using a stored - energy Kolsky bar. The advantage of the Kolsky bar method is that it provides a direct measurement of the existing interfacial conditions and does not depend on material deformation behavior like other methods to measure friction. The method also provides both static and dynamic coefficients of friction, and these values could prove relevant for microextrusion tests performed at high strain rates. Tests were conducted using brass samples of a small grain size (32 µm) and a large grain size (211 µm) at low contact pressure (22 MPa) and high contact pressure (250 MPa) to see whether there was any change in the friction conditions due to these parameters. Another parameter that was varied was the area of contact. Static and dynamic coefficients of friction are reported for all the cases. The main conclusion of these experiments was that the friction coefficient did not show any significant dependence on the material grain size, interface pressure, or area of contact.

Opini Anda

Klik untuk menuliskan opini Anda tentang koleksi ini!

Kembali